JBC flux 500ml

This flux from JBC is designed to be used in PCB preparation prior to soldering a PCB component. The flux leaves no residue and can be used for up to 6 months after opening.

How to use

• 1 Clean and degrease the surface.
• 2 Use the brush to apply the flux to the integrated circuit pads
• 3 Solder the joint.
• 4 Flux left behind does not cause any electrical or chemical problems. If there is a residue you want to remove, use water.

Specifications

Téléchargements

MSDS JBC flux

(84.85 KB)

Télécharger